Shure Shure Axient AD1 Taschensender 470-636MHz

Zum Kauf stehen 14 Shure Shure Axient AD1 Taschensender 470-636MHz.
wie neu. Wenige Einsätze

SYSTEM SPECIFICATIONS (SUBJECT TO CHANGE)
RF
RF Carrier Frequency Range 470–960 MHz
Varies by Region. See Frequency Range and Output Power Table.
Working Range 100 m (330 ft)
Note: Actual range depends on RF signal absorption, reflection and interference.
RF Tuning Step Size 25 kHz
Varies by region.
Image Rejection >70 dB
typical
RF Sensitivity −98 dBm at 10-5 BER
AUDIO
Latency Standard mode: 2.0 ms
High Density mode: 2.9 ms
Audio Frequency Response
AD1: 20 Hz–20 kHz (±1 dB)
AD2: 20 Hz–20 kHz (±1 dB)
ADX1: 20 Hz–20 kHz (±1 dB)
ADX1M: 20 Hz–20 kHz (±1 dB)
ADX2/ADX2FD: 20 Hz–20 kHz (±1 dB)
Note: dependent on microphone type
Audio Dynamic Range
A-weighted, typical, System Gain @ +10
XLR Analog Output: 120 dB (A-weighted); 117 dB (unweighted)
Dante Digital Output: 130 dB (A-weighted); 126 dB (unweighted)
Total Harmonic Distortion
–6 dBFS input, 1 kHz, System Gain @ +10 <0.01%
System Audio Polarity Positive pressure on microphone diaphragm produces positive voltage on pin 2
with respect to pin 3 of XLR output and the tip of the 6.35 mm (1/4-inch) output.
TEMPERATURE RANGE Note: Battery characteristics may limit this range.
Operating Temperature Range 0 to 122 °F (−18 °C to 50 °C)
Storage Temperature Range −20 to 149 °F (−29°C to 65°C)

SPECIFICATIONS
(SUBJECT TO CHANGE)
Gain Offset Range –12 to 21 dB (in 1 dB steps)
Battery Type SB900A Rechargeable Li-Ion
or LR6 AA batteries 1.5 V
Battery Run Time
@10 mW
Shure SB900A: up to 9 hours
Alkaline: up to 8 hours
Dimensions
(H × W × D)
3.4 × 2.6 × 0.9 in
(86 × 66 × 23 mm)
Weight 5.47 oz (155 g)
wihtout batteries
Housing Cast Aluminum
AUDIO INPUT
Connector 4-Pin male mini connector (TA4M)
LEMO3 Connector
Configuration Unbalanced
Impedance TA4M: 910 kΩ
LEMO3: 8.2 MΩ
Maximum Input Level
1 kHz at 1% THD
Pad Off: 8.5 dBV (7.5 Vpp)
Pad Off: 20.5 dBV (30 Vpp)
Preamplifier Equivalent
Input Noise (EIN)
System Gain Setting ≥20
–120 dBV
A-weighted, typical
RF OUTPUT
Connector SMA
Antenna Type 1/4 Wave
Impedance 50 Ω
Occupied Bandwidth <200 kHz
Modulation Type Shure Axient Digital Propietary
Power
2 mW, 10 mW, 35 mW
Varies by region. See Frequency Range and
Output Power Table.
Specific Absorption Rate
(SAR)
<0.20 W/kg
AVAILABLE MODELS
AD1-TQG Axient Digital Bodypack, TQG (TA4M)
Connector
AD1-LEMO3 Axient Digital Bodypack, LEMO3
Connector

Irrtümer (Preis, Abbildungen, Artikelbeschreibung) und Verfügbarkeit unter Vorbehalt.
Das Gerät kann bei uns vor Ort getestet werden.
Verkauf erfolgt unter Ausschluss von Gewährleistung oder Garantie