Shure Axient AD4DE 2-fach Empfänger 470-636 MHz

Zum Kauf stehen 2 Shure Axient AD4DE 2-fach Empfänger 470-636 MHz. Sehr guter Zustand, sehr wenige Einsätze

SYSTEM SPECIFICATIONS (SUBJECT TO CHANGE)
RF
RF Carrier Frequency Range 470–960 MHz
Varies by Region. See Frequency Range and Output Power Table.
Working Range 100 m (330 ft)
Note: Actual range depends on RF signal absorption, reflection and interference.
RF Tuning Step Size 25 kHz
Varies by region.
Image Rejection >70 dB
typical
RF Sensitivity −98 dBm at 10-5 BER
AUDIO
Latency Standard mode: 2.0 ms
High Density mode: 2.9 ms
Audio Frequency Response
AD1: 20 Hz–20 kHz (±1 dB)
AD2: 20 Hz–20 kHz (±1 dB)
ADX1: 20 Hz–20 kHz (±1 dB)
ADX1M: 20 Hz–20 kHz (±1 dB)
ADX2/ADX2FD: 20 Hz–20 kHz (±1 dB)
Note: dependent on microphone type
Audio Dynamic Range
A-weighted, typical, System Gain @ +10
XLR Analog Output: 120 dB (A-weighted); 117 dB (unweighted)
Dante Digital Output: 130 dB (A-weighted); 126 dB (unweighted)
Total Harmonic Distortion
–6 dBFS input, 1 kHz, System Gain @ +10 <0.01%
System Audio Polarity Positive pressure on microphone diaphragm produces positive voltage on pin 2
with respect to pin 3 of XLR output and the tip of the 6.35 mm (1/4-inch) output.
TEMPERATURE RANGE Note: Battery characteristics may limit this range.
Operating Temperature Range 0 to 122 °F (−18 °C to 50 °C)
Storage Temperature Range −20 to 149 °F (−29°C to 65°C


SPECIFICATIONS
(SUBJECT TO CHANGE)
Dimensions
(H × W × D)
1.7 × 19.0 × 13.1 in
(44 × 483 × 333 mm)
Weight 10.1 lb (4.6 kg)
without antennas
Housing Steel; extruded aluminum
Power Requirements 100 to 240 VAC, 50–60 Hz
0.68 A max
Thermal Dissipation Maximum: 23 W (78 BTU/hr)
Idle: 15 W (6
AUDIO OUTPUT
Gain Adjustment Range –18 to +42 dB in 1 dB steps (plus
Mute setting)
Configuration
1/4" (6.35 mm): Transformer-coupled Balanced
(Tip=audio, Ring=no audio,
Sleeve=ground)
XLR: Transformer-Coupled Balanced
(1=ground, 2=audio +, 3=audio –)
Impedance
Typical, XLR Line Out 100 Ω
Full Scale Output
200 kΩ load
1/4" (6.35 mm): +8 dBV
XLR (LINE setting): +18 dBV
XLR (MIC setting): –12 dBV
Mic/Line Switch 30 dB pad
Phantom
Power Protection
Yes
NETWORKING
Network Interface 10/100 Mbps, 1 Gbps, Dante Digital
Audio
Network
Addressing Capability DHCP or Manual IP address
Maximum Cable Length 100 m (328 ft)
CASCADE OUTPUT
Connector Type
BNC
Note: For connection of one additional
receiver in the same band
Configuration Unbalanced, passive
Impedance 50 Ω
Insertion Loss 0 dB, typical
RF INPUT
Spurious Rejection >80 dB, typical
Connector Type BNC
Impedance 50 Ω
Bias Voltage 12-13.5 VDC, 150 mA maximium, per
antenna, switchable on/off
RF Carrier Frequency
Range
Model-Dependent
AD4D=A: 470–636 MHz
AD4D=B: 606–810 MHz
AD4D=C: 750–960 MHz

Irrtümer (Preis, Abbildungen, Artikelbeschreibung) und Verfügbarkeit unter Vorbehalt.
Das Gerät kann bei uns vor Ort getestet werden.
Verkauf erfolgt unter Ausschluss von Gewährleistung oder Garantie